Awasome How To Light A Gas Fireplace With A Lighter Ideas. First, make sure the gas is turned off on the fireplace. Don’t hold it down for too long in case any excess gas escapes.
How to Light Gas Fireplace Pilot without Ignitor from www.easyhometips.org
Gas fireplace pilot lights user guide. Hold the valve in the light position for 30 seconds until you. The pilot knob should have the options “off,” “pilot” and, in some models, “on.”.
Hold The Valve In The Light Position For 30 Seconds Until You.
The fire should be lit. Remove the access cover to the controls. Press the control knob down and hit the ignition switch.
The First Think You Want To Do Is Pull The Cover Off The Fireplace.
Turn the knob from the “off” to the “pilot” position. The doors should be open whenever you are operating the gas log system. With the gas fireplace lit, replace any covers to the fireplace.
Hit The Ignition Button Until The Fire Lights.
If you don’t see any button, you must light the flame manually. This pilot has a piezoelectric starter, so you don't need to hold a flame next to the pilot to light it. Click the piezoelectric igniter a few times until the pilot lights.
The Gas Valve Knob Usually Has A Round Metal Flange With A Square Or Hex Hole In The Center.
Next, light your lighter and put its flame near the pilot light inside the fireplace or furnace, or press the clicker button to make sure that it is sparking (this may be hard to see in some fireplaces).now press the knob, or a button near the knob, to get gas flowing to the pilot light.often, this will involve manually depressing the pilot valve and using an electric ignitor. Ensure that the valve is properly aligned with the gas line of your fireplace for ultimate control of the flow of the fuel. Remember to do this when you are ready to ignite the pilot light of your gas fireplace.
Turn On The Gas Key By Twisting The Gas Valve Knob Counter.
Tap the switch until the pilot light ignites. Press and hold the knob in. Find the fireplace’s ignition switch (usually a red button on the device or by the wall switch) and push it for a second at a time repeatedly until it lights the gas.
